This is the standard wall fitting for all Splash pools after 1999. This is the wall fitting that is located at the skimmer suction point, and the return. If you have a single skimmer setup, there are two (2) of these on your pool. If you are running duel skimmers then there are four (4) of these on your pool.

This is NOT the wall fitting for the skimmer hold down. That is a different wall fitting and you can find it on this site.

If you only need the gaskets, please order the gasket kit for the wall fitting. If you order this item, you will get the complete wall fitting with gaskets, as shown in the picture.

The installation order for the gaskets is one rubber gasket on the male portion that goes through the wall of the pool. One the inside of the pool you will place another rubber gasket, then the fiber gasket and then the nut. The fiber gasket allows you to tighten the nut without pinching the rubber gasket.